Stickman400
12-28-2011, 08:37 PM
Well as most of you guys know I am tearing my 400 down to the frame and PC'ing it and then gunna rebuild it and paint or PC other parts here and there to spice it up a bit. Now I'm still in the debating phase of what colors I want to do with the swinger and stuff so I'm just going to list what I am planning on doing and then get some feedback from you guys. I am open to discussion so don't hold back. I'll also post a pic of my current setup that I have. I'm not getting new plastics, graphics or rims so I'm gunna have to go with some kind of Red/Black/White combo here I'm afraid.
Frame: Black
A-Arms (I may be getting black Housers so this might not even happen): Red uppers and Black lowers.
Swinger: Black or Red
Calipers(front and rear): Red
Little parts on the engine(timing hole caps, etc.): Black
Oil Tank and Cooler: Red
Rear Brake Stay: Black or Red
Spindles(not sure if I want to paint these): Black
Hubs(currently gray from factory): Red
Sub-Linkage(arm from linkage to swinger): Red
Nerf-Bars: Black or Red
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/IMAG0320.jpg
Frame: Black
A-Arms (I may be getting black Housers so this might not even happen): Red uppers and Black lowers.
Swinger: Black or Red
Calipers(front and rear): Red
Little parts on the engine(timing hole caps, etc.): Black
Oil Tank and Cooler: Red
Rear Brake Stay: Black or Red
Spindles(not sure if I want to paint these): Black
Hubs(currently gray from factory): Red
Sub-Linkage(arm from linkage to swinger): Red
Nerf-Bars: Black or Red
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/IMAG0320.jpg