BULLET99Z28
12-15-2011, 05:45 PM
86 harness/CDI/aftermarket coil-good shape, never been spliced into, I have it wired for a Pro-Design kill switch. Completely unwrapped the old tape, cleaned the wires and re-wrapped it. It is partially unwrapped because I swapped in a complete 89 setup after the stator went bad and unhooked the Kill switch. Kill switch was wired into blk/white cdi wire, ground to frame w harness ground
50 obo
http://i182.photobucket.com/albums/x237/BULLET99Z28/2011-12-21141426.jpg
Complete 89 igniton-harness,flywheel,stator,pickup,oem coil, ngk cap/wire,cdi(No regulator though). I bought this from RedRed(pete) in mid october just so I could take the R on vacation over Halloween. All parts were new oem from previous owner(who used it very little), who also went w the CR250 ignition. I rode it maybe an hour since installing. I bought a CR250 ignition, so I won't be needing this. Coil on this I bought from the same guy about a month before buying the whole ignition(NIB OEM) Excellent parts here, very little use.
$120- SOLD
http://i182.photobucket.com/albums/x237/BULLET99Z28/2011-12-21141241.jpg
319-491-3489. Feel free to call, Nate
50 obo
http://i182.photobucket.com/albums/x237/BULLET99Z28/2011-12-21141426.jpg
Complete 89 igniton-harness,flywheel,stator,pickup,oem coil, ngk cap/wire,cdi(No regulator though). I bought this from RedRed(pete) in mid october just so I could take the R on vacation over Halloween. All parts were new oem from previous owner(who used it very little), who also went w the CR250 ignition. I rode it maybe an hour since installing. I bought a CR250 ignition, so I won't be needing this. Coil on this I bought from the same guy about a month before buying the whole ignition(NIB OEM) Excellent parts here, very little use.
$120- SOLD
http://i182.photobucket.com/albums/x237/BULLET99Z28/2011-12-21141241.jpg
319-491-3489. Feel free to call, Nate