quick question

[01boneless]

this is a dumb question but im gonna do the header mod and was wondering if id have to go up on any jets or can i just go out a half a turn on the a/f screw

[honda400ex2003]

imo you might have to go up 1 size but it would depend on how much material you take off and how close to being lean you are currently.

give it a couple of runs with some chops and see how it looks then go from there to make your decision on going up or not.

just my .02 though,
steve

[01boneless]

well its border line lean now ( just pops very little on decel) so i better not do it and just turn a 1/4 out to do away with the poping cause i doubt the header mod does anything lol thanks steve

[honda400ex2003]

do a comparison based on what you find. i did my header when i did my 416 so i just did all the jetting at the same time.

steve