Minndave13
08-11-2011, 08:03 PM
I am putting on ASV levers and I have to remove the Headlight/Kill/Start switch. I got a dirt bike kill switch and hooked it up, bike works good. I hooked up the headlight to run on high and low beams, bike runs good. Put when I hooked up the new kill switch the quad does not start, (the solenoid just clicks). I jumpered the two wires that went into the original kill switch and the quad starts right up. I have a Gunner Closed circuit kill switch (a closed switch is specified by Dynatek). any suggestions?