i think i need a new seal or bearing

[yz450f rider]

ok while i was tying differant clutch springs today i notied the shaft that comes out the motor/case is really wobbely or lose i can move it up and down and side by side what all would i need to fix this problem i pretty shure its not suppose to do this and should it be bad already with only about 2 hrs on it

[jerkyboy]

They all move a little. If your worried about it take the tranny cover off and make sure the washer is holding the bearing in place. remember to drain the fluid first.

[yz450f rider]

i guess it would be called the primary gear it is preety bad i an see the clutch and belt wobbleing around ingauged

[nitrofish]

It will be "wobbely" without the cvt cover on. The bearing in the cover takes care of that. I'm sure it is fine. Just don't crank her too hard with the cover off when your looking at the belt travel and such. Matt.

[yz450f rider]

oh i see it does make sence thanks for the info i was getting ready to order thanks:)