Burns310r
08-03-2011, 06:04 PM
Cylinder is on 77mm bore, needs a hone job and another 77mm piston and will run. I set the motor up to tight this last time and caused it to seize.
So with the hone job it will have the .005 clearance that is needed to make these motors run good. The engine made amazing power when i was on the track. I ran 14/37 gearing, and it would pull the front wheels in 4th gear with out issue.
Pictures to come
It has a pump gas and race gas dome with it, and a billet exhaust flange
$465 Shipped.
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0034.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0032.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0033.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0031.jpg
So with the hone job it will have the .005 clearance that is needed to make these motors run good. The engine made amazing power when i was on the track. I ran 14/37 gearing, and it would pull the front wheels in 4th gear with out issue.
Pictures to come
It has a pump gas and race gas dome with it, and a billet exhaust flange
$465 Shipped.
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0034.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0032.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0033.jpg
http://i158.photobucket.com/albums/t82/BurnsMGT/IMG_0031.jpg