stever250r
07-25-2011, 11:13 AM
Couldn't find this anywhere and since several others out there have been building Laeger Quads I am sure someone can tell me what mount hardware to use for the Laeger Steering Stem.
I am thinking that the design eliminates the need for the lower collar but I just wanted to be sure about that.. So do I just need a bolt and a washer big enough to hit the steel lip where the lower Dust Seal is installed? That doesn't seem right to me either because then the washer would want to bind or spin against whatever it was tightened down against.. Maybe the collar is required?... I am lost here....
Can someone tell me how to do this, and if it requires that I order the Hardware from Laeger's?
I am thinking that the design eliminates the need for the lower collar but I just wanted to be sure about that.. So do I just need a bolt and a washer big enough to hit the steel lip where the lower Dust Seal is installed? That doesn't seem right to me either because then the washer would want to bind or spin against whatever it was tightened down against.. Maybe the collar is required?... I am lost here....
Can someone tell me how to do this, and if it requires that I order the Hardware from Laeger's?