WTB: intake boot

[sand_blaster]

I need a intake boot for the larger carbs. I'll take it if its in good condition.
Thanks.

[danhung11]

That 86 one I sent you will work, I've had these OEM style boots on 38-39mm PWK's. What size carb are you going after?

Run it in hot tap water and start massaging it to free it up. Then have your carb there with you, and once it starts getting soft - stretch it over and let it cool down. You can now take it on and off in short periods of time and have it retain it's "stretched" size.

Hope this was what you are after, otherwise this post sounds really bad...LOL!

[sand_blaster]

You never sent me a boot, only the air shrouds.
I bought a brand new 39pwk from ESR. Stock 87 boot is old rubber. I actually tried the hot water trick got it jammed in there right now, but figured its better to buy a brand new one then keep using stock one.

[danhung11]

My bad. No boots for sale here.

[brokenbones]

I have a oem one from esr will that work for ya

its new never been bolted up

shoot me a offer

[sand_blaster]

Thanks for the offer, but I have to get this 250r done asap , so I just bought a upp from ebay today.