PDA

View Full Version : help help trx 450r wont start



ramsey450r
06-30-2011, 04:56 PM
tried different ignition, coil, spark plug, plug cap. does not seem to be firing when i kick. fan turns when im kicking. please help any ideas?????

DnB_racing
06-30-2011, 05:05 PM
do you have spark? does it run is push started?

what year? have you done any mods since it ran? when did it stop running? have you done anything that would make it not run? wire harness or carb ?....

for a good answer you have to ask a good question with every detail you can think of

with your question we have no idea of were to start

could be a fuel issue or a motor issue or a electric issue, but without more details everything would be a wild guess

ramsey450r
06-30-2011, 05:11 PM
not sure if i have spark. didnt try pushing yet. bike started earlier on today but went really bad, backfiring alot would not rev. took off ignition sprayed with wd40 put back on bike went great, then came back in took ignition off again to let dry out and went for dinner and bike will not start since then.

ramsey450r
06-30-2011, 05:13 PM
2006 no mods since last time it was out went great then.

DnB_racing
06-30-2011, 05:15 PM
do you know how to check the stator and coils for resistance?

ramsey450r
06-30-2011, 05:18 PM
dont know how to do that

DnB_racing
06-30-2011, 05:29 PM
here is a link for a free service manual, wait 45 seconds and a free button will popup then download the free one and you will see the electrical trouble shooting section in the ignition chapter http://www.megaupload.com/?d=I1LMLX10

matt1106
06-30-2011, 06:20 PM
when was the last time you adjusted your valves?

Pacheco_450r
06-30-2011, 08:36 PM
Not sure if the 06's have the hot start cable but I had the same symptoms on my 05 and it was my hot start cable that had frozen wide open. I soaked it over night in liquid wrench and it was good as new.

ramsey450r
07-01-2011, 03:44 AM
valves were set about a month ago. will look at hot start tonight but i think its ok the lever fo it is still moving fine

DnB_racing
07-01-2011, 04:56 AM
Originally posted by ramsey450r
valves were set about a month ago. will look at hot start tonight but i think its ok the lever fo it is still moving fine do your know if its a spark issue or fuel or other? start narrowing it down for us so we can help

ramsey450r
07-01-2011, 03:14 PM
got the problem at last. one small broken wire. bike going great again. thanks for the reply's.