hawaiianbasshed
06-16-2011, 01:40 AM
whats the length from the center of ball joint to the center of front pivot hole on the upper and lower arms?
I'm doing some research so far
z400 is 11 1/2" upper arm, 13" lower arm
250r is 12" upper arm, 14" lower arm
so there are slight variance between the three, but usually can be made up for I believe with adjustable ball joints and tie rod ends. I have a project that is different however so need to find out prior. spindle will also come into play but for now I'm starting with the arms. thanks,
Tom
I'm doing some research so far
z400 is 11 1/2" upper arm, 13" lower arm
250r is 12" upper arm, 14" lower arm
so there are slight variance between the three, but usually can be made up for I believe with adjustable ball joints and tie rod ends. I have a project that is different however so need to find out prior. spindle will also come into play but for now I'm starting with the arms. thanks,
Tom