Powder Coating A-Arms

[B.C.#11TRX400EX]

wat do u guys do to powder coat the a-arms when u can't take off the ball joints?

[CJM]

I wouldnt even bother powder coating the stock arms, they are junk compared to anything aftermarket.

Id paint them.

[426kidz]

leave them the way they are till you get some new ones. stock look bad painted in my oppinion.

[B.C.#11TRX400EX]

wats the best aftermarket? is walsh or lonestar any good?

[CJM]

Walsh, lonestar, houser, etc are all top notch and $$$. Yes they are good but you really pay for it. Id look into JD performance or burgurd,. They are cheaper but build quite nice.

Are you planning on widening the front or do you just want adjustable from arms? FYI: +1 means +1" on both sides, +2 is 2" on both sides and +3 is 3" on both sides. So each side gains that measurement.

Stock EX width is about 45 inches, anything over 48-50 inches will make it hard to ride on most trails.

[B.C.#11TRX400EX]

yeah i new that haha i would probably get +2 arms, and yeah i dont no, im gonna be racing cross country and im tryin to get all the parts i want for it ready

[CJM]

+1 is what you want for cross country, anything wider is WAY to tight on most trails.

[B.C.#11TRX400EX]

alright thanks man