aaron496
06-07-2011, 05:51 AM
Trying to get rid of some extra parts, prices are shipped except the engine. Paypal fee's are not included they will be added, or you can send a m/o PM or email redeyecustoms@yahoo.com I have more pics of the parts i can e-mail if needed
1.. 87 cylinder ported mid to top, I used it for tt racing, worked very well. It looks like its 68.5mm now , bore is still in good shape can be used again. needs a new piston. I used a 86 piston with a spacer plate $90.00
2.. complete engine with esr 350 cyl. 86 bottom end just replaced 3rd gear, crank bearings, had crank rebuilt by by dave moore was balanced and welded, all new seals and gaskets, cly needs to be bored. the oring started leaking and it scuffed the cly its at 79mm so there is one bore left. It has some porting done by a local shop for tt/flattrack, ran very good would pull almost any 450 down the staight's bottom end could use new paint SOLD
3..lrd pipe, 250b adjustable, one very minor ding, slightly discolored, needs to be cleaned inside. Had an egt probe in it, Hole has been welded shut $90.00
4..carbon fiber grab bar, This was on my bike for 4 months for testing its still in great shape its very light about 6 onces, will fit 88-89 (narrow bolt pattern) $90.00
5.. aluminum axle, adjustable -2 to +4 all splines are tight, axle is straight it has 4-115 hubs on it but I had it on my 250r $265.00
6..grab bar, not sure of the brand its in great shape, was polished $35.00
7..grab bar, old ac, its been used has weld repairs, not in great shape 15.00
8.. kich start, no knuckle $10.00
1.. 87 cylinder ported mid to top, I used it for tt racing, worked very well. It looks like its 68.5mm now , bore is still in good shape can be used again. needs a new piston. I used a 86 piston with a spacer plate $90.00
2.. complete engine with esr 350 cyl. 86 bottom end just replaced 3rd gear, crank bearings, had crank rebuilt by by dave moore was balanced and welded, all new seals and gaskets, cly needs to be bored. the oring started leaking and it scuffed the cly its at 79mm so there is one bore left. It has some porting done by a local shop for tt/flattrack, ran very good would pull almost any 450 down the staight's bottom end could use new paint SOLD
3..lrd pipe, 250b adjustable, one very minor ding, slightly discolored, needs to be cleaned inside. Had an egt probe in it, Hole has been welded shut $90.00
4..carbon fiber grab bar, This was on my bike for 4 months for testing its still in great shape its very light about 6 onces, will fit 88-89 (narrow bolt pattern) $90.00
5.. aluminum axle, adjustable -2 to +4 all splines are tight, axle is straight it has 4-115 hubs on it but I had it on my 250r $265.00
6..grab bar, not sure of the brand its in great shape, was polished $35.00
7..grab bar, old ac, its been used has weld repairs, not in great shape 15.00
8.. kich start, no knuckle $10.00