2001400exrida
06-02-2011, 09:05 AM
I've got a 2004 with basically a stock bore. I think it's like .02 over just because we did a slight bore and hone. So it's bored 2 over and it has a 13:1 compression piston with stage 2 hotcams and a slip on pipe. where should my jetting be?
also this thing had a bit of a hang idle before i got it, i turned the idle down and it has stopped, is that wierd that the idle was maxed out and now it actually runs right? it would idle lower but it just hung there and didn't idle back down after i let off the gas. could it be the carb slide or what?
also this thing had a bit of a hang idle before i got it, i turned the idle down and it has stopped, is that wierd that the idle was maxed out and now it actually runs right? it would idle lower but it just hung there and didn't idle back down after i let off the gas. could it be the carb slide or what?