Forged Piston

[2007R]

I have a 2007 TRX 450R, and i have the motor apart for some transmission work and i was going to put a piston in it while it was tore down. I was planning to go with a wiseco 96mm 13:5:1. My question is will this piston work with out doing any cylinder work. The stock bore on a 2007 TRX is 96mm correct?

[DnB_racing]

Originally posted by 2007R
I have a 2007 TRX 450R, and i have the motor apart for some transmission work and i was going to put a piston in it while it was tore down. I was planning to go with a wiseco 96mm 13:5:1. My question is will this piston work with out doing any cylinder work. The stock bore on a 2007 TRX is 96mm correct? yes the stock bore is 96mm and its coated and shouldn't be honed or bored unless you plan on re coating,

and as long as you haven't decked the head you should be able to run a crf head gasket to help bump your compression a little more..

13.5:1 with a crf gasket and good cam (hc2, or a 02 crf cam, or a hrc cam) will really wake it up with a good exhaust and air filter, you will be happy with the results

[2007R]

Alright thanks, see i didnt know if i could run the forged piston without doing some cylinder work. Thanks again, ready to get it back together for sure!!