BULLET99Z28
05-18-2011, 02:21 AM
Thinking about using the cr250r reed cage and intake combo on my motor to go w/ a 38mm airstryker. What years seem to be the best to look for, i have seen some good deals on ebay for the cage assembly and intake boot.
I know that I will need a reed cage spacer if I use the CR intake, but how thick, is there kind of a standard size most spacers are? I currently have a spacer.
Laslty, how does this setup compare to a Boyesen rad valve? Motor specs- CT 310 cylinder with bottom/mid range port, 38mm airstyriker, and for now a FMF fatty pipe. I plan to run woods, back roads, atv parks, maybe some MX and XC racing if that helps.
Thanks fellas
I know that I will need a reed cage spacer if I use the CR intake, but how thick, is there kind of a standard size most spacers are? I currently have a spacer.
Laslty, how does this setup compare to a Boyesen rad valve? Motor specs- CT 310 cylinder with bottom/mid range port, 38mm airstyriker, and for now a FMF fatty pipe. I plan to run woods, back roads, atv parks, maybe some MX and XC racing if that helps.
Thanks fellas