What is the screw thats missing on this carb?

[1993SSP]

Missing a screw on my carb, not sure which one it is. It was gone when I got the bike.

http://i125.photobucket.com/albums/p79/1993SSP/ebay021.jpg

[DnB_racing]

from the perspective of that pic its hard to tell ... but it looks like your air screw is missing.... take a side shot and post it .... but im almost positive its your airscrew

[1993SSP]

That would explain some of my running issues I am going to assume!

[DnB_racing]

Originally posted by 1993SSP
That would explain some of my running issues I am going to assume! lol ya!!! you might be running just a little lean!!! dont run it any more until you get it fixed... hopfully you havent caused any damage

[1993SSP]

Well, when I got the bike it was running like crap somewhat, pipe, silencer and air filter are only mods. Plug was BLACK and it had a 162 jet in it. I dropped to a 160 and it runs better then I noticed that was missing. I just bought a carb kit on ebay since my bowl gasket is shot. I will not be running it anymore until I get that screw and the gasket.

Suggestions on setting that screw properly when I get it? Where should the clip be on the needle valve as well???

[DnB_racing]

screw in all the way until it LIGHTLY bottoms out and back out about 3/4 turns and start there

have you adjusted a carb before? if not there are some good artical to read google carb adjusting and several will come up and take you through the whole priciplals of adjusting... here is one link but there are many others http://hondanighthawks.net/carb14.htm