Blaster Wont stay Running

[tide2085]

I have a 2000 Blaster that wont stay running.. I can start it and it will run for a few seconds and then die. Also when you hit the throttle a little bit it bogs out and dies.. i was just wondering if you guys could tell me stuff i should check out. thanks

[trx250xtim]

when was the carb last cleaned

[tide2085]

Not to long ago but I'm going to take it apart and clean it again

[JAG Motosports]

Check the reeds too..have u checked to make sure its getting fuel

[badasprn]

if your e brake is on it wont rev. there is a safety switch sometimes gets stuck on if you have had the e brake on.

[bloodswet&gears]

OUR BLASTER STARTED DOING THIS SAME THING. WHEN WE FIRST BOUGHT IT IT WOULD HIT BUT NOT RUN. I PULLED THE FLYWHEEL TO SEE IF THE KEYWAY WAS SHEARED BUT FOUND THE SOURCE COIL SCREWS HAD BACKED OUT AND THE FLYWHEEL WAS HITTING IT. LOC-TITE THE SCREWS BACK IN AND IT RAN FOR A WHILE.

RECENTLY IT STARTED ACTING UP WOULD RUN FOR A WHILE. POP SPUTTER AND DIE. I TESTED EVERYTHING. THE SOURCE COIL OHM'D OUT O.K. SO I CLEANED CARB AGAIN, TRIED ANOTHER COIL, ALOT OF DIFFERENT THINGS. PULLED THE FLYWHEEL OFF AND THE SOURCE COIL IS FRIED. OHMS OK TILL YOU WIGGLE IT.
AND YOU SHOULDNT BE ABLE TO WIGGLE IT.

IF ALL ELSE FAILS YOU WAY WANT TO PULL THE FLYWHEEL AND CHECK STATOR COMPONENTS.

[trx250xtim]

Dude, caps-lock is annoying.
spray some ether in the carb and if it fires then its not getting fuel. Also with any quads I've had or rode, it will bog if it isn't warm and you touch the throttle (simple logic). Will it run if you keep the throttle going?

[bloodswet&gears]

[QUOTE]Originally posted by trx250xtim
[B]Dude, caps-lock is annoying.

WELL DUDE, I THINK GOOFY SIGNATURES TELLING POEPLE WHAT KIND OF GRIPS, PLASTIC, NERF BARS AND TIRES YOU HAVE IS ANNOYING.

READ THE POST RULES. IF YOU DONT LIKE IT IGNORE IT.MOVE ON TO THE NEXT.

I WAS TRYING TO HELP THIS GUY THATS WHAT THESE FORUMS ARE FOR. NOT WHAT ANNOYS YOU. TALK TO YOUR MOM ABOUT THAT.