Ccan I still use this carrier?

[Zakradu398]

It got pretty chewed up when a bearing decided to explode , what do you think?

http://i148.photobucket.com/albums/s31/zakrad_u/Mobile%20Uploads/IMG_1929.jpg


http://i148.photobucket.com/albums/s31/zakrad_u/Mobile%20Uploads/IMG_2996.jpg

[Zakradu398]

Anyone?

[nelzar13]

its hard to tell by the pic but the areas you showed are inboard of where the bearings sit.... can you get a shot of the that? i thinkg then we can tell you if its possible to blast some new bearings in there.. but i can tell you, my carrier is in absolutly terrible condition, chewed up everywhere. and it still hold my bearings just fine... just get us a pic of where the bearing sits and will give ya an awnser

[Zakradu398]

It is good where the bearings sit, it's just between them is bad

[trailrider894]

HECK NO!! I would never use something if it was even the least bit scared... Get a new one.

[CJM]

Nope, t and t racing makes anice one with bearings installed for 100 bucks on ebay.

[hocman123]

if the inside were the bearings ride and the inside of the spacer were the axel rides is smooth then i would reuse it but if the spacer is bad in the inside and u put the axel in u could end up with a scorned axel

[nelzar13]

i did the same thing to my carier about a month ago. just grab some bearings from ebay and give it a try... worst case senario your out 20 bucks for a set of bearings if it doesnt work.. and if it does work out it will give you some time to hie a couple bucks away for a nice double row set up ! if the bearing surfaces are ok give it a wirl i say

[Zakradu398]

Well, worked good today. Next time it needs bearings Ill just get a double row, thanks everyone