PDA

View Full Version : Quick question on sub issue



redlineranger
04-26-2011, 12:41 AM
Long time since I've been on this site. I seen a few sub forums were up but I didn't wanna rob them with my problems so here it is. And from what I gather there's a few guru's on this site so yes I'm lookin for you to help!

Got a new truck and swapped my system over with brand new everything wire wise goin to the subs, amp, head unit..the works. Hooked everything up and it beat like a champ for a couple days maybe a week or two I don't remember. After that something went amiss. When fooling around a little bit, I found that when the ignition is just turned over and truck NOT running, they'll slap all day. But when I crank the truck and IS runnin, nothin happens and the blue power light on the amp is flashing. Need your help.

Thanks in advance!

YFZ-FoFiddy-TC
04-26-2011, 02:04 AM
Sounds like the amp is going into protection but that doesn't make sense if it works while truck isn't running. See how much voltage you're getting through the power wire without it running, then how much when it is running.

Kickstarts-suck
04-26-2011, 07:25 PM
What kind of amp? Check voltage of power and the remote wires.

Good ground?