rf928
04-24-2011, 02:14 PM
Hey everyone,
We have installed new swing arm (+2) and axle (2+2) on yamaha blaster, and on the new swing arm the back seems wider than stock, and the sprocket alignment is off from the front by an entire sprocket width. Is there something we have done wrong? We did press the bearings in as far as they could go.
Thanks for the help
We have installed new swing arm (+2) and axle (2+2) on yamaha blaster, and on the new swing arm the back seems wider than stock, and the sprocket alignment is off from the front by an entire sprocket width. Is there something we have done wrong? We did press the bearings in as far as they could go.
Thanks for the help