nastynotchback1
04-15-2011, 06:04 AM
malossi air cooled motor built and ported by Billy holt.
Dr pulley variator with 3.75 rollers
787 belt
stage 6 clutch set at 6700rpm by the tach
ztr 1500 spring
metrakit pro race pipe
ported koso intake w/carbon reeds
d-slide 24mm carb
bike ran very well but we went to a new bike so i removed the 28mm carb that was on it and put on the new bike.this bike has been sitting for about 5 months.put this used 24mm carb on it and i have jetted it every way i can and it will not run right.Fires up the first kick and idles fine.it will rev good the first time you hit the throttle but if you hold it at half throttle it will slowing start to die out.at this point it will not rev well and will not idle well until you let it cut off.Kinda like it is running out of fuel.Think the carb is just bad.It's a used carb i got with the motor along time ago but i never tried it out until now.
Dr pulley variator with 3.75 rollers
787 belt
stage 6 clutch set at 6700rpm by the tach
ztr 1500 spring
metrakit pro race pipe
ported koso intake w/carbon reeds
d-slide 24mm carb
bike ran very well but we went to a new bike so i removed the 28mm carb that was on it and put on the new bike.this bike has been sitting for about 5 months.put this used 24mm carb on it and i have jetted it every way i can and it will not run right.Fires up the first kick and idles fine.it will rev good the first time you hit the throttle but if you hold it at half throttle it will slowing start to die out.at this point it will not rev well and will not idle well until you let it cut off.Kinda like it is running out of fuel.Think the carb is just bad.It's a used carb i got with the motor along time ago but i never tried it out until now.