View Full Version : Need Advice, motor quit
nwi45
04-14-2011, 08:33 PM
Motor was running fine, no power loss. Engine bogged and died. Kicked and started up but would bog out and die. Small flame coming out of exhaust. Did a search but didn't cone up with much. Haven't taken anything apart just wondering where to look to start.
TheLane
04-14-2011, 08:40 PM
Hows your carb look??
Also do you have an electronic throttle control?
nwi45
04-14-2011, 08:57 PM
FCR carb. Nut sure if it has electric control. The carb is clean. Just cleaned recently
Fast470r
04-15-2011, 01:07 AM
I could be wrong but it seems like a lean condition with the bogging and back firing if its an fcr maybe go up a pilot size and look into a leak jet size 55 and if it isnt go up to a size 50 pilot and my fcr has the plug in but its off an 08 hope this helps ya.
nwi45
04-15-2011, 04:31 AM
Wasn't necessarily backfiring. There was just a small flame coming out of exhaust when it wasn't running.
Ruf Racing
04-15-2011, 07:45 AM
Doesn't sound like a fuel issue, if it was running fine. More likely, ignition issue. Ground, maybe stator? :ermm:
ss440ex
04-15-2011, 12:13 PM
Originally posted by Ruf Racing
Doesn't sound like a fuel issue, if it was running fine. More likely, ignition issue. Ground, maybe stator? :ermm:
I would ck into the two wires on the coil, then look under the hood for any wires bent over/broke at the connector.
Mine had the same problem last week,found a broken wire held on by three strands.
Good luck.
eastside 400
04-15-2011, 04:12 PM
check your timing/valve clearances. stators can do some wierd things too.
TheLane
04-15-2011, 08:15 PM
Check to see if you have an electrical cable coming out of your throttle housing.
Also check to make sure you dont have more than 1-2/8ths of an inch in play in your throttle.
Powered by vBulletin® Version 4.2.1 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.