CanuckR
04-07-2011, 03:20 PM
Ok so I bought a set of motoquad a arms from a guy. Turns out one of the lower ball joints is pooched. (I specifically asked if they where still good) Besides the point.
So today I go about taking them out to figure out a replacement.
They are rebuildable?
You remove a snap ring, and the bottom of the joint comes out. There is a half a cup with a spring. Then the king pin falls out. Then there is the top of the ball joint cup that u can push out.
I've never seen an atv with ball joints like this.
I don't even know where to look.
Any ideas?
So today I go about taking them out to figure out a replacement.
They are rebuildable?
You remove a snap ring, and the bottom of the joint comes out. There is a half a cup with a spring. Then the king pin falls out. Then there is the top of the ball joint cup that u can push out.
I've never seen an atv with ball joints like this.
I don't even know where to look.
Any ideas?