a arms and hubs

[reconracer64]

ok guys i just got a 250r last week and i have a set of 400ex jb racing a arms they a arms fit with spacers like the cross compatibility chart said they would but when i put the hubs on its like the top of the wheels would be pointed in a lot like this / \ if u know what i mean now u can adjust the ball joints to take some of that out but not enough do u think when its all together and on the ground the shock sag will take the rest of the angle out....im using 450r shocks

any help would be greatly appreciated thanks

[reconracer64]

the wheels are like this / \ sry bout the last one

[skyhighatv]

I've had the opposite prob..i run roll lobo2 arms for a 400ex on my r and i had to cut the jamb nuts in half for the heims so i could get the camber i wanted,on a positive note being that u use the spacers for the 400 arms it gives u the capability of running more positive or negative caster..jaysin

[reconracer64]

yea thats true i just want to know how to fix why they are angled so bad i thought that is was because the shocks were to long but the works shocks that i took off and only like half in shorter

[reconracer64]

hey guys can someone please chime in on this i really need some help...i turned the hubs upside down and it made the wheels straight like they should be...this is really blowing my mind

[Honda 250r 001]

Pics, Pics, Pics man...

[CanuckR]

If the bike is suspended (tires off the ground) the tires will be a lot more like this / \ as opposed to more straight up and down. The tires go through a lot of camber change during suspension cycle. Put the rims and tires on and set the bike at ride height and check again.
Derek

[reconracer64]

yea so i think i have it figured out it doesnt make sense with what everyone says but i was using 400ex spindles because i have billet 400ex hubs that i want to run so i just took the 400ex spindles off and put on the 250r spindles and hubs and the problem is fixed now i wanna know if u can run 400ex hubs on 89 250r spindles

[CanuckR]

Im 99% sure that you can run 400ex hubs on 89 spindles