TrX450er14
03-23-2011, 06:01 PM
plz read
ok i have a big problem here lol and was needing some advice... i have a ltr450 with walsh uppers and stock bottoms with fox floats and i recently redone my colors and was powdercoating my a arms and nerfs and they turn out really nice but the problem is that the stock bottom bearings that connect to the spindal had plastic in it and it melted... i asked some ppl if they thought it would b ok and they said ok so i went ahead and done it... big mistake but any how i was planning on cutting the stock bearing off and threading a tie rod end where the stock one is. do you think it will b fine to race like that i would think it would be just as strong or stronger but i thought i would ask what you all thought....
thanks
ok i have a big problem here lol and was needing some advice... i have a ltr450 with walsh uppers and stock bottoms with fox floats and i recently redone my colors and was powdercoating my a arms and nerfs and they turn out really nice but the problem is that the stock bottom bearings that connect to the spindal had plastic in it and it melted... i asked some ppl if they thought it would b ok and they said ok so i went ahead and done it... big mistake but any how i was planning on cutting the stock bearing off and threading a tie rod end where the stock one is. do you think it will b fine to race like that i would think it would be just as strong or stronger but i thought i would ask what you all thought....
thanks