cylinder head alignment dowels

[IMSROLL450R]

Hey fellas I am puttin my motor together today and was about to put the head on and noticed I am missing the alignment dowels between the cylinder and head. Anyone have a couple they'd come off of? I've scoured my plethera of parts and cant find any. Let me know if you do. If not I'll get on parts-direct and order some but didnt wanna wait that long to get the motor buttoned up. Thanks fellas.

Jerid

[IMSROLL450R]

Dang nobody?

[NMills]

I know it may be a worse case thought... but they did not happen to fall in the bottom end did they???? it's just a thought..
You may just wanna order them.. get new ones... that way you get the right ones and without damage...

[IMSROLL450R]

Originally posted by NMills
I know it may be a worse case thought... but they did not happen to fall in the bottom end did they???? it's just a thought..
You may just wanna order them.. get new ones... that way you get the right ones and without damage...

Nah I just lost em in the rebuild over the last 8 months. Guess I will order some just in case. I always keep the bottom end covered so hopefully theres nothing in there.

[2001400exrida]

there's only 2 isn't there?
where the head goes on.

I am just curious because i only had 2.

[NMills]

i believe there is only 2... on any section of the engine... there always a pair...

[IMSROLL450R]

I stole 2 of them out of a 372ex we have apart so I got the motor back together. Check out my thread labeled "01 Red and Black Build"