help setting up gt thunder shocks

[SicRipp83]

hey everyone just got my shocks revalved not to long ago, and the snow has cleared enof to run around a bit. i noticed that gt has the adjustment screw backed all the way out, and the spanner nuts with not pressure on the springs i need sone suggestions on how to set these up. im leaving for hat&mccoy in 6 days any help would be great thanks

[dustin_j]

Laz has very good instructions on his website that might be helpful. Otherwise, set your castor (if adjustable), camber, and toe. You'll want to re-check each one at the end since they all affect each other. Then set rear sag to 4 - 5 inches. 4 is for more aggressive, and 5 is for a more plush setup. The goal is minimal spring preload, if you need more than 3 turns, you need a heavier spring. Then set front preload so the front of the frame is .25" higher than the rear (ride height). I would try (and mark down) where Laz has the comp and rebound adjusters set, then adjust from there if you see need. Hope this helps.