Help!!!!! Quick!!!!!!!!!!!

[hunter61]

i have an 07 450er with a houser swingarm lonestar exyended axle, running stock carrier , stock axle nut and the other day when i was riding my axle nut came loose and tried to tightten it, and would get sorta tight and just spin over......... so i thought it was stripped so i ordered new threads and nuts and tried again and got it in last night and its doing the same as before. if anyone can help quick need tthe bike rolling a.s.a.p.
thanks

[dyno]

If your'e runing out of threads, check the slleeve and bearings in the carrier! Also sometimes the aluminum sprocket flange wears on the axle!

[hunter61]

i put new bearings in it last night while it was apart..... and not sure if its the sprocket flange will check.....any other ideas?

[DnB_racing]

is the retaining clip in place? or is the clip worn to the point that the antifad is sliding out???

[hunter61]

yes it in place and is not worn......... its likethere is not enough threads to tighten it

[DnB_racing]

are you sure its not pushing out???like over the clip??

[hunter61]

i was tring to hold the clip in with 2 screwdrivers. and no luck, taking it to local motosports shop today for them to look at.....maybe it something simple.

[AtvKid4Eva]

take the clip off the axle and squeeze it with some pliers to make it smaller and put it back on the axle..it should fit a lot snugger and hold in the groove. my guess is its coming out of the groove when you tighten it up..or just get a RAD locknut or an anti fade hub..good luck