Pro Armor Kill Switch Installation Help

[Bradracer18]

Guys-

Bought a Pro Armor kill switch, and it has two wires. I think it doesn't matter which one goes where, but one needs grounded...and the other obviously to a power source. (for my 03 pred 500)

Has anyone installed these or can point me to the wire I need to tap into? Instructions say to splice into the wire between the stator and ignition coil is what most atv's require.....however no specific instructions for the pred.

Thanks!
Brad

[Bradracer18]

nevermind....figured it out!

[TheLane]

Would you mind sharing the knowladge for us who are mechanicallytarded?

[ride red 14]

pretty simple on the predator. ground one of the wires to the frame, and the other one splice into the blue/white wire coming off the coil.
depending on what predator you have, some of them are factory wired for the tether. if thats the case, plug and go. they will be 2 wires coming off your key switch harness, can't remember the colors.