timing plate torque specs?

[Zakradu398]

How many ft lbs does it need to be tightened too?

[Hondamaster5505]

I wouldn't worry too much about it. Just tighten it good and snug.

I didn't really torque anything on my motor when I rebuilt it, and it's holding up just fine. :)

[Zakradu398]

I figured but didnt want to strip anything

[Hondamaster5505]

Just don't go too crazy. Doesn't have to be incredibly tight.

[Zakradu398]

I read it's possible to modify the stock one for ±4 deg advance. How do I go about this

[Hondamaster5505]

Originally posted by Zakradu398
I read it's possible to modify the stock one for ±4 deg advance. How do I go about this

Basically just taking a dremel and elongating the holes. You have to be careful though not to go too far. You should look up how much to cut it. I don't recall off hand.

My father recently picked up an aftermarket stator plate. I'm going to be taking the dimensions off the holes and modifying my stock one.

[Zakradu398]

If you happen to come across how much needs cut for +4 deg. let me know.

[Hondamaster5505]

Originally posted by Zakradu398
If you happen to come across how much needs cut for +4 deg. let me know.

Will do. Later on tonight, ill measure the aftermarket one to see how many (mm) it needs to be cut and let you know.