ESR billet head torque

[Hutchracer]

I just bought a ESR head for my 310 motor and I forgot to ask about the torque specs. Would it be the same as stock specs or are they different? I've also never done a head with O-rings is there a good or a bad way to do it as I haven't taken the cast head off to look at yet it may be self explanitory but I thought I would ask just to be sure.
I had shoulder surgery and have had to look at a half finshed project for to long so it's time to finsh the build and get the motor up and running.

[norcalduner]

12 ft-lbs

[profab250R]

mine called for 22 ftlbs via ESR recomendations.

[rablack21]

Mine does as well.

[norcalduner]

my bad ..... you guys are correct at 22 ft. lbs.

[Hutchracer]

Sounds good to me I was thinking 12 was a little light but I figured to keep on checking can't hurt. thanks for the info

[Grande Huevos]

i would put some grease on those o rings before u tighten the head down to ensure they stay in place and u get the proper seal