Stock dust boot work with ASV brake lever?

[NacsMXer]

Just like it says. If you have an ASV front brake lever, does it fit ok under the OEM rubber dust cover?

Thanks guys

[Dave400ex]

You can make it work and cut the stock one some, but ASV does offer a front dust cover for the lever.

[NacsMXer]

Ok thanks, so you have to cut the stocker to fit then huh?

It looks like stock cover offers better protection than the ASV unit. I was comparing the two and wasn't sure if the stock one would work without cutting. Thanks man.

[airmobile101]

IDK if you have to cut it or not. I didn't, and mine works just fine. It might be depending on the type of ASV lever you use.

[Dave400ex]

Yeah I'm not 100% sure if cutting would be needed. The bike I looked at had cut it some. I have ran the ASV dust cover for the past 3 years without issues though.

[Baileygunns]

My stock cover fit. I didn't have to cut mine, it fit right over no issues.

[PottersRacing22]

asv cover ebay is $8

[NacsMXer]

Just wanted to post back and update.

I ordered the cover and it fit the ASV lever no problem. I'm using a 450R master cylinder, 450R dust cover, and 400EX ASV lever. Thanks for everyone's input, I didn't want to spend on the cover and have it not fit.

http://img521.imageshack.us/img521/9482/dsc0850b.jpg (http://img521.imageshack.us/i/dsc0850b.jpg/)

http://img262.imageshack.us/img262/7566/dsc0852d.jpg (http://img262.imageshack.us/i/dsc0852d.jpg/)