new look for 300

[??300expro??]

here are some pic of my new front plastic :cool:

[??300expro??]

another

[??300expro??]

one more

[DEAL]

looks good man:macho

[exriderdude]

nice:chinese:

[250x#93]

Looks nice:macho

[Sparks425Ex]

Looking Good.

[??300expro??]

:cool: thanks:cool:

[300exracer]

Looks good.:D :macho

[coryatver]

Looks good. nice dog to.

[exriderdude]

hey ??300expro??... what is a 300ex tech kit??

[bigbadbrad]

how do you like your wheel spacers? and were they hard to put on? and how hard was the plastic to put on?

[??300expro??]

(how do you like your wheel spacers?) There ok but sometimes I brake ball joint on the tie rods.(were they hard to put on?)no, the back were the eaziest, on the front i had to take the disk off the hub to slide the longer bolt in the stude holes.(how hard was the plastic to put on?) The plactic was pretty simple, but you have to take off the hande bars, to slide the on then just bolt them up.

[tants]

IMO you should trim those rear plastics so there cut strait

[toby400ex]

i would think you would seriously bottom your front shocks with those spacers, it also looks like your front wheels are turned out too:huh

[TRX250XFIRE]

I like the looks for that yellow to, i like how wide ur front is to, how many ball joints have u gone threw? i have the same plastic on my X but red.

[??300expro??]

(i would think you would seriously bottom your front shocks with those spacers, it also looks like your front wheels are turned out too)

never bottom these worksshocks out there set for 165 lb.
I am 140lb.

(I like the looks for that yellow to, i like how wide ur front is to, how many ball joints have u gone threw? i have the same plastic on my X but red.)

I have gone threw about 5 and it has been about a year with the spacers.

[??300expro??]

:scary: :devil