BENT - 250ex or 300ex axle

[mod_driver43]

just as subject title says.
looking for a BENT 250X or 300ex axle. CHEAP.

it is going to be cut so if at least 1 side is good i will take it.

[Baileygunns]

250EX is shaft drive and the 300EX is chain drive... (250X is the same as the 300EX)

I have a 250EX axle if you're interested.

[mod_driver43]

sorry you are correct..
i need a 250X or 300EX axle

[cik orange]

i have one that is already cut in scrap pile

[mod_driver43]

Originally posted by cik orange
i have one that is already cut in scrap pile


how much you want for it cik?

i need at least 10" of the straight side plus good splines. will the one you got work?

thanks

[cik orange]

i will check but i think i got it

[Baileygunns]

So... I have to ask... What are you doing with it?

If the one cik has doesn't work, I have a 250X roller on the side of the garage that I could knock the axle out of... I was planning on putting the stock 450R axle I have in it anyhow.

I have two 250EX axles if you decide you want one of those.

The one in the 250X roller was missing a hub when I picked it up so the right side splines are rusted from sitting on the ground...

I'll let it go for shipping cost and $7.99 for a 6 pack of Sam Adams Winter Ale... The Sam Adams are to motivate me to get off my *** and pull the axle, lol.

[cik orange]

this is what i have splines are good but you might have to chase the threads. lets say $20 covers shipping and i like the 6pack idea

and i'm wandering also what you are going to do with this

[mod_driver43]

it is actually going to be used for a dune buggy rear drive spline. i have one side done already, but need another to complete the rear.
i turn down the shaft and key it to fit inside some impement u-joints.
does that explain it enough? if not will send a pic and let you see what i am talking about.

[mod_driver43]

cik, how much is shipping to 65613? located in bolivar, MO

[cik orange]

$20 dollars shipped

[mod_driver43]

cik,

pm how you want to be paid?

thanks

[cik orange]

pay pal is fine

[fastredrider44]

Too bad you're not interested in 450 axles. I gotta stack of em.:o

[cik orange]

pm'd ya

[cik orange]

contact me ternang94@att.net