can somebody help me here

[muddzilla94]

im trying to take my flywheel bolt off and im not having a bit of luck, almost as bad as removing my pivot bolt , tried 2 different impacts and it wont even budge it. should i heat it up or somethin to help get i off?

[DnB_racing]

did you try locking the right side gears with a penny? thats how I got mine off

Use a 6 pound sledge and the correct wrench. put the wrench on the nut and swing the hammer like a axe and she should pop right off.

that was a joke. do what DnB_racing said.

[muddzilla94]

i havent tried to lock my gears yet with a penny but i will go try in a minute and let you know if it works. if it dont i might end up doing what roostar said:devil:

[dran714]

lots of lube we use some stuff at work called silikroil u can only get it for industrial use but it works.. anyway lube and torque the puller down and tap with a hammer and watch out it will pop and may fly off there.. good luck

[muddzilla94]

i got it off with a impact with about 200psi going to it

[desratt]

flywheel isn't reverse thread is it? seemes like the nut wasn't bad it was actually pulling it off that was hard.

[DnB_racing]

Originally posted by desratt
flywheel isn't reverse thread is it? seemes like the nut wasn't bad it was actually pulling it off that was hard. once the nut is off use the flywhell puller like dran714 says, and it will pop off sometimes with power behind it!!!

[muddzilla94]

i removed the flywheel also, used a gear puller and it popped right off.