Steering stem is stuck,trying to remove!HELP!

[socal]

I have a YFZ and the frame was powdercoated,the bearing was not pressed in properly and now I cant get the stem out.The gas tank and upper clamp are removed,bottom castle nut and tie rod knuckle are removed.I stood it up and pounded the living $hit out of it after soaking it with penetrating oil,and it wont budge!It spins freely but wont slide out.Any suggestions would be appreciated.Thanks...

[duroc825]

Did you remove the snap ring on top of the bearing? If so a little heat always does wonders, just be careful not to overheat! What are you "pounding" it with? A socket and hammer is generally a good bearing press. Good luck.

[ridehonda400ex]

if its rusted for some reason...PB Blaster does a good job

[socal]

The top bearing was not seated properly.I was able to use a large c-clamp and take the binding out a bit and several whacks later,it came out!Thanks....