rotor hittin the caliper??

[wayfastwhitey69]

i took my rear end apart to put new bearings in the carrier and when i put it back together and went to put the caliper back on it wouldnt fit between the rotor and the caliper mount. i loosened off the nut and got it to go on but when i tighten it up it still hits. it doesn't hit too bad i can still turn the axle but i dont know why its hitting now because it never did

[Jason Hall]

Is the rotor bent to one side? Did you get the bearing's seated all the way Into the carrier?

[wayfastwhitey69]

no its not bent and ya there in all the way i dont understand why its hitting now ive put bearings in it before and have had no problem like this before

[D Bergstrom]

Since you took the rear apart, could have put it together wrong, see this post:

http://www.exriders.com/vbb/showthread.php?s=&threadid=445748&perpage=10&pagenumber=1

Maybe not the problem, but worth checking.

Doug

[eastside 400]

take a picture of your problem, i cant totally understand where its hitting