Log in

View Full Version : My Motor Mounts


muff
02-08-2003, 12:52 PM
check out the motor mounts I polished today, actually I only have one side of one of them done but it came out good considering I only went up to 600 grit dry sandpaper
muff
02-08-2003, 12:52 PM
before and after
DantheEXman
02-08-2003, 01:57 PM
good job
:chinese: :chinese:
Sparks425Ex
02-08-2003, 06:33 PM
Are those the ones I just sent to ya.(Trans Red One) Or are those the ones that are on my quad right now?
Pappy
02-08-2003, 06:36 PM
looks good:D
02-08-2003, 07:29 PM
ill trade ya. mine for ur polished ones lol
muff
02-08-2003, 07:31 PM
Originally posted by Nacs425ex
Are those the ones I just sent to ya.(Trans Red One) Or are those the ones that are on my quad right now?

no these are a different set that I had bought
Pappy
02-08-2003, 07:45 PM
muff.....i might have some work for ya:)
muff
02-08-2003, 07:49 PM
Originally posted by Pappy
muff.....i might have some work for ya:)

sounds good

another pic, and no your not cross eyed
RUFIO
02-09-2003, 05:17 PM
Im in the process of chroming the whole frreakin quad...currently im on the motor mounts....my nerf were connected to them as most are are and i took the two bottom screws out...but the top one is connected to eachother when i take them out will the engine be able to hold itslef up for awhile of will I have to put something there to hold her up for a while
racin 400
02-09-2003, 06:20 PM
the bottom mounts and headstay will keep it in place.or to be safe put a wrench between the frame and motor to be on the safe side.
muff
02-09-2003, 06:31 PM
yea you dont have to worry about it movin, theres 2 other bolts holdin it in place
RUFIO
02-10-2003, 01:09 PM
thanks
MX26
02-10-2003, 06:40 PM
Originally posted by muff
sounds good

another pic, and no your not cross eyed

Hey, the chick in that paper is pretty hott lookin ;)
honda400exrider
02-10-2003, 06:52 PM
exactly how do u do this?:devil lol
killed300ex
02-10-2003, 07:34 PM
im with him how the **** you do this? Here is what i think you take like 300grit sand paper sand it then keep going with fner sand paper untill you get to like 1000 grit then take some mothers and just kinda polish it up with that but im not exatly what you need to do the polishing? any one help me out if i want to do some parts with just a rag work to polish it up?
killed
muff
02-10-2003, 07:42 PM
i start at 220, then 400, 600, then 1000 and 1500 once i get the paper, once the part is smooth use a buffing wheel (see pic below) I use a die grinder the red thing($30-50) hooked up to an air compressor ($300), with the compounds off www.eastwoodcompany.com apply the compound to the buff and then take it to the metal