Rear brake resivoir question

[06 300ex red]

i got a fmf full exhuast on my quad and it goes right below the rear brake resivoir. There is like 1" or a little less of clearence between the pipe and resivoir. Is that a problem getting hot or will it be ok? is there something to keep it cooler?

[gr race]

i wrapped my line with heat tape i also took the res. off and then remounted in on the inside of the frame to get more clearance

[06 300ex red]

oh ook, i didnt know if i could slap a heat shield on it like there is on the rear plastic or not to keep it cooler

[smr]

it will most likely be OK. Your rotor gets hotter than your exhuast. Just make sure you use DOT 4 flued and everything should be fine.

[06 300ex red]

alrighty, thanks