shortest height tire for 10" rim?

[hawaiianbasshed]

we currently have 19x6 holeshot MXs on the front of my sons bike but they rub the new AC nerfs. are the new DWTs shorter or anything else shorter?

thanks!

Tom

[RCR_531]

I have the same problem with the XFR nerf bars. I am going to take some flat stock and make a bracket so I can move the Nerf bars back a little. Just going to drill 4 holes in the flat stock and grid some off of the nerf bar bracket to make it fit over the stock bracket on the quad. I can afford to loss anymore ground height by going with a smaller tire. There is a 18x6x10 front tire out. Good luck

I think that this is the tire
http://www.maxxis.com/MotorcycleATV/ATV-Sport/M943M-Razr-iMX-Front1.aspx

[hawaiianbasshed]

I know the razr TT come in a 18x6x10 but I can't find an 18x6 off road tire :(

iMX or other :(

[RCR_531]

Parts Unlimited has them in their catalog. Your dealer or one on here should be able to get them for you.

[hawaiianbasshed]

http://www.parts-unlimited.com/product/getProductDetails.do?regions=6&segmentId=13&comCodeId=239&subComCodeId=&itemOffset=40&pageSize=20&productId=54342

only see 18 for rear??

I'm thinking I'll just ditch the AC nerfs and put the DGs back on, this is turning into a huge pita :mad: stupid bike... stupid nerfs... stupid bike+ stupid nerfs = gonna drop it off a cliff...

[RCR_531]

JR MX Front - 18.5x6-10
0321-0298 $54.95
$49.46

This is a DWT you are right on Maxxis it was miss labeled. Atleast you don't have to go very far to find a cliff. :]

[RCR_531]

made the brackets today. 6 inchs long 3 inches wide flat stock.sawall,grinder and drill to make them. I now have an 1.5 inches between the front tires and nerf bars at the closes spot

[hawaiianbasshed]

got a pic? I'm thinking I may just move the damm nerfs as well :( sounds cheaper than tires lol

[RCR_531]

I will get some up tonight. Send me your mailing address and I will send you a card board template. Rodney

[hawaiianbasshed]

I have an LT80 and the nerfs are AC, I'd need two relocation brackets it looks like to me. one for the front and one for the rear mount that goes to the foot peg thing.

I'm gonna try to pull the front wheel spacer off and see if that helps, I think it will. but it will just narrow the front of the bike 3" lol. we'll see. got a set of trx450r nerfs I'm busy making fit my LTR LOL so I'll just pull the front spacers on the 80 and see if that works for now.

I would like to try the DWT Jr series tires front and back but for now I'll run the setup I currently have on it if I can make it work.