what would cause this???

[ridein'red7]

so i figuerd out my oil leak it is leaking out the base gasket on the jug they are all brand new cometic gaskets i have order new tusk ones i hope it will cure it what do yalls think?

[CJM]

Warped jug perhaps? improperly torqued? Broken gasket perhaps?

[ridein'red7]

jug was all checked out and fine and i torqued the bolts to 33lbs thats wha ti was told to do and the gasket was brandnew but i didnt put gasket shlack on it and i didnt put it on the head gasket to

[3400ben]

Make sure the surface that the gasket comes in contact with is clean.

[CJM]

I never use that gasket shellac stuff, no issues.

When you torqued it, did you do so in a pattern? If you just torqued one at a time it probably isnt torqued right.

[togup]

When you take you jug off look for pry marks or gouges ,run your finger nail across the bottom of the jug and the top of the case. Personally i do not use a base gasket because I like to eek out every little bit of performance(however small) I can.

[ridein'red7]

figured it out there was gasket left over from before i got it and i could see it because it blended in but there was at least half a gasket lol now i need to figur out the starter