Case Repair help

[Honda 250r 001]

OK i dont have pictures, but i can describe pretty good. where the two cases meet, and the gasket seals between the two. Theres a spot where there is gouge in the sealing surface... Enough so that it wont seal. so can i even the edge out with jb weld? or should i have to have this welded? the gauge is about as thick as a nickle...

[skippy1999]

screwdriver pry mark?

[Honda 250r 001]

yea, its about double wide compared to the normal screwdriver width though.

Have them welded and re-surface the case parting lines...

Call BDT Motorsports 909-802-6516...they repaired all my case bores and I am sure they can weld and re-surface the center cases for you.