Eton TXL90 Question

[svtctr]

Dripping fuel into the air inlet and it runs fine but when i hook it up to the carb i doesnt want to even start, should the carb be rebulit?

[riding4fun]

Pull the carb completely, take it apart and clean thoroughly. Remove all jets and blow out with compressed air.
It can't hurt.

[svtctr]

thanks ill give it a try and let u know

[svtctr]

work for a little while but then it would just bog down and really couldnt go anywhere but it does run better and will idle like a champ

[riding4fun]

OK, so it idles now.

What does it do when you ease on the throttle and what happens when you stab the throttle.

[svtctr]

bogs when i ease into it and almost dies when i stab it

[riding4fun]

What kind of carb and what jets are currently in it.

[svtctr]

how would i find out what carb it is cause as far as i know its stock and its got an electric choke, i would love to get rid of electric and go manual and dont know anything about the jets

[riding4fun]

Just pull the carb off and look at it to see what make it is.. The jetting numbers are on each jet. If you want to put a better carb on it with manual choke. Look in the for sale section for a pe24 carb. It works great on 90's. You should be able to find one for around $50

[svtctr]

ok kool ill look at it and get back with you but as i was looking at it more closely i found out that this thing is a 50cc not a 90 like i was told when i bought them, wish i knew that then cause i wouldnt have bought it, but is the carb the same for the 50cc?

[riding4fun]

PM sent

[svtctr]

its all fixed i just replaced the spark plug and tuned the carb and its all good thank you all for your help