f4iracer
08-13-2010, 07:25 PM
My clutch cable recently broke on my ltr 450 while i was out riding.
I'm trying to install the new one and i can't seem to figure out where i went wrong down by the motor.
I took the actuator arm off of the shaft that goes into the motor. I installed the cable down onto it.
The shaft moves freely from left to right and i'm not sure where i need to put the arm back on at it. There are splines on it.
Do i turn the shaft all the way to the left or to the right? I am not even able to get the clutch to engage at all, i tried rolling the quad while it was in gear and then moving the shaft and i couldn't get it to engage my clutch.
any help is appreciated, thanks in advance!
I'm trying to install the new one and i can't seem to figure out where i went wrong down by the motor.
I took the actuator arm off of the shaft that goes into the motor. I installed the cable down onto it.
The shaft moves freely from left to right and i'm not sure where i need to put the arm back on at it. There are splines on it.
Do i turn the shaft all the way to the left or to the right? I am not even able to get the clutch to engage at all, i tried rolling the quad while it was in gear and then moving the shaft and i couldn't get it to engage my clutch.
any help is appreciated, thanks in advance!