2007 Predator 500 air/fuel mixture screw

[Dmanrider20]

I think Im over looking where my air/fuel mixture screw is, if anyone can try to explain or point it out in a pic. Id appreciate it:) Thanks

[alleskovar]

It is behind a brass plug. The plug needs to be carefully drilled out. The carb needs to be off the bike. If you are having a hard time starting or irratic idle/choke while cold, please check out the valve shim adjustment thread on this board. It worked for me after rebuilding/jetting and pulling out much hair tinkering with the carb ......Anyhow, it's on the bottom behind the brass plug. Once you put the carb back on it will be a biatch to get to. I had to make a mini screw driver and use fingerless gloves to make the adjustment. The gloves kept the heat from the engine from burning my hand....Good Luck!

[Dmanrider20]

I took the brass plug off and there was something that had a c clip on it. Do I take that out, and its behind that?

[Dmanrider20]

I figured it out. Thanks:)
I just got a kandn filter just a little tweekin