Blingstar iron cross fitment ?

[logan909]

I have seen many DRR minis with blingstar iron cross bumpers but I just got off the phone with them and they do not make one for DRR ?? does the polaris or the kasea fit the same or is there a ton of fab involved ?

[JAG Motosports]

Ours was for a Eton. Had to bend the brackets out a bit. Wasn't hard.

[bulldogfallon]

JAG- Was that on the AC or LC quad?

[kfx450]

our Iron cross bumper has complete custom brackets. We were going to use a kasea bumper on our liquid cooled drr but the small cross is only 9 inches wide, dosn't cover the radiator. So we ordered a 12 iron cross bumper and made custom mounts. In my opinion that is the way to go as the factory mounts are made to alow the bumper to roll when hitting somthing and that would destroy the bumper. Our cross is bent in half with the radiator in good condition. Racing in the woods is hard on bumpers.

[logan909]

i do not see eton ? on the website ? I am not as worried about the rad due to the fact that we race mx and not gncc if it is that bad of a collision it is not going to make a difference? so in your opinion's ? would you buy POLARIS ? Kasea? suzuki lt80? trx90?

[JAG Motosports]

Originally posted by bulldogfallon
JAG- Was that on the AC or LC quad?

Oh ya my bad, ac

[kfx450]

The kasea bumper looked like it would be very close in fitment on an air cooled but with the radiator it would not fit at all bottom mounts looked good but uppers weren't close

[nastynotchback1]

i have it backwards.i have a drr rath bumper on the kasea and i had to make upper mounts.the lowers fit perfect.