No pull on clutch

[mkbruteforce]

I replaced my clutch fibers and plates because of a slipping issue. All I replaced or touched where the old fiber and plates and replaced them with new ones. When I put is all back together my clutch lever has zero pull. There is no tension on the lever itself and the cutch will not engage. Any ideas?

[Scro]

Did the push rod get taken out somehow?

[JOHNDOE83]

Becareful, I once snapped the rod by putting on the right cover without allowing the rod to properly go into the slot on the shaft in the cover, I was tightening the cover down and heard a snap, took it apart to find the rod tip had broke right off.

[fearlessfred]

Originally posted by Scro
Did the push rod get taken out somehow? or the puck that the flat needle bearing sits on,or if its old style with the single ball bearing maybe the bearing fell out

[mkbruteforce]

Thanks for all the replies. I fixed it last night.

[Scro]

What was the problem?