4bidden
07-23-2010, 04:42 PM
This motor was just completely disassembled and gone through by Racers Edge AZ. The only thing that needed replaced was the shift shaft because it was slightly bent. The motor, and the majority of the parts in it, including Crankworks OEM balanced and welded crank, cam, valves, springs, piston, etc, have 2 practices and 1 race on them. Absolutely fresh and mint motor. I know people will ask how much HP. I've had it on a couple different dynos and it is between 58-62hp.
Racers Edge CNC epoxy port job
Ferrea valves (+1 exhaust)
Kibblewhite valve springs/retainers
Hotcam Stage 3
Crankworks balanced OEM crank with welded pin
CP 13.8:1 race piston
Dark Synergy clutch springs
OEM Honda clutch
$1600 FIRM + shipping. If you're in Southern CA or AZ I can meet you.
Here is a picture to show you how fresh and clean this motor is. Looks like its never been ran.
(NOTE: I adjusted the shadows on this photo cause it was gloomy outside and the ports weren't lit up well)
Racers Edge CNC epoxy port job
Ferrea valves (+1 exhaust)
Kibblewhite valve springs/retainers
Hotcam Stage 3
Crankworks balanced OEM crank with welded pin
CP 13.8:1 race piston
Dark Synergy clutch springs
OEM Honda clutch
$1600 FIRM + shipping. If you're in Southern CA or AZ I can meet you.
Here is a picture to show you how fresh and clean this motor is. Looks like its never been ran.
(NOTE: I adjusted the shadows on this photo cause it was gloomy outside and the ports weren't lit up well)