scary132
07-04-2010, 04:02 PM
The pivot point at the crankcase / bracket to the frame has become sloppy on my 1988 LT80 from wear. (has quite a bit of side to side play).
I pulled it apart and was going to order new bushings. Bolt is fine. Bracket seems fine but the bolt has a little play in the bracket.
Is the bracket from the frame to the crankcase pivot a wear item that I need to replace? Don't want to spend the extra $30 if I don't have to. Or will the new bushings tighten it up?
Thanks
I pulled it apart and was going to order new bushings. Bolt is fine. Bracket seems fine but the bolt has a little play in the bracket.
Is the bracket from the frame to the crankcase pivot a wear item that I need to replace? Don't want to spend the extra $30 if I don't have to. Or will the new bushings tighten it up?
Thanks