KBooth
06-30-2010, 12:10 PM
http://www.ktmatvhq.com/forum/invision/index.php?showtopic=5559
Follow link for pics
2008 KTM 450xc Located in Western NY below Buffalo.
Frame and Body Parts
SX A-Arms
New Handlebar Bridge
New pivot bolt
New Front brake pads
New Swing arm bearings
New powder coat on many parts all parts possible
New Maxxis Razrs onr front
New rear beadlocks with new tires
Newer White KTM plastic
Orange Quad Tech Hood
Quad tech seat cover with mx foam for lower ride height
Honda throttle housing
KTM front bumper
KTM full body skid
KTM frame guards
Rath propeg nerfs
New front wheel bearingsFront Shocks revalved and sprung by Baldwin Motorsports and Factory KTM. (Best I ever raced on)
Rear has Hygear spring kit and Race Tech Valving with Race Tech rebound separator
ENGINE
New wiesco piston and rings 12.5 compression ratio
Falcon crank Blue printed
New water pump
New CV4 radiator hoses with thermostat delete
New intake flange between carb and head
4.1 FMF exhaust with mega bomb header
R&D float bowl with adj. leak jet
Striped wiring harness done by Baldwin with dirtbike CDI
Brembo Clutch setup easy pull (used by most Factory riders)
Just completely went through motor to check crank and transmission. Asking $7,500 obo If interested e-mail me at Kab9029@aol.com
Would consider trades for ultility with or with out a plow.
or UTV
Follow link for pics
2008 KTM 450xc Located in Western NY below Buffalo.
Frame and Body Parts
SX A-Arms
New Handlebar Bridge
New pivot bolt
New Front brake pads
New Swing arm bearings
New powder coat on many parts all parts possible
New Maxxis Razrs onr front
New rear beadlocks with new tires
Newer White KTM plastic
Orange Quad Tech Hood
Quad tech seat cover with mx foam for lower ride height
Honda throttle housing
KTM front bumper
KTM full body skid
KTM frame guards
Rath propeg nerfs
New front wheel bearingsFront Shocks revalved and sprung by Baldwin Motorsports and Factory KTM. (Best I ever raced on)
Rear has Hygear spring kit and Race Tech Valving with Race Tech rebound separator
ENGINE
New wiesco piston and rings 12.5 compression ratio
Falcon crank Blue printed
New water pump
New CV4 radiator hoses with thermostat delete
New intake flange between carb and head
4.1 FMF exhaust with mega bomb header
R&D float bowl with adj. leak jet
Striped wiring harness done by Baldwin with dirtbike CDI
Brembo Clutch setup easy pull (used by most Factory riders)
Just completely went through motor to check crank and transmission. Asking $7,500 obo If interested e-mail me at Kab9029@aol.com
Would consider trades for ultility with or with out a plow.
or UTV